This is a simple 2.5D single sided CNC woodworking project: a bread bow knife handle! My neighbor David came over and wanted to cut some of these out, so we drew up this design in Autodesk Fusion and cut them out on the CNC. I ported the design over to Vectric VCarve 11.5 with my settings that I used.
Included files:
- Bread Bow Knife Handle.pdf – Super basic directions / notes
- Bread Bow Knife v2.f3d – Autodesk Fusion file
- Bread Bow Knife Handle v2.crv – Vectric VCarve file (11.5 or higher)
- Bread Bow Knife Handle v2.dxf – The outline of the handle as a DXF vector for other software
- Other files: some various Adobe Illustrator files and text images for fun engravings (Carpe Panem)
Materials / Bits:
- Blades: https://link.amazon/B04xA1uG6
- 1/4″ downcut bit: https://amzn.to/3RQ1FIj – Whiteside
- 1/4” downcut bit: https://amzn.to/3BVZ0bH – or Freud
- 1/4” spiral upcut bit: https://amzn.to/3UcWaFM – Whiteside
- 1/4” Radius Rounding over bit: https://link.amazon/B07HtcVzQ – Freud
- 1/4” flush trim bit / pattern bit: https://amzn.to/48bWTg5 – Whiteside
- Toe Clamp Hold downs to 3d print: https://www.corbinsworkshop.com/shop/low-profile-cnc-toe-clamps-for-t-track-hold-downs-with-nut-tightener-handle-3d-printable-out-of-pla/
- VBit Inlay Plugin for Fusion: https://www.corbinsworkshop.com/software/
NOTE: I drilled the 1/4″ hole with a drill bit, but you can use a 1/4″ upcut bit instead.
NOTE: some links are Amazon Affiliate links where I earn a small commission when you buy something, but these are the actual products I used!






